Ktm 950 R Bedienungsanleitung PDF herunterladen (Seite 56)

Adjusting the headlight range

The payload can make it necessary to correct the headlight range.

The headlight range can be adjusted with the adjusting screw [1]. Turning in a clockwise

direction will reduce the headlight range, turning in a counterclockwise direction will increase

the headlight range.

TO CHECK:

Determine the distance from the ground to the center of the headlight when your motorcy-

cle is loaded and ready for the trip (baggage, driver, passenger). Make a mark on a light wall

behind a level surface at a height corresponding to the center of the headlight. Position your

motorcycle loaded ready for the trip 5 meters (16,4 ft) away from the wall and switch on

the low beam. The light/dark cut-off line should be 5 cm (2 in) under the mark (see

drawing).

Replacing the flasher bulbs

Remove the screw on the back of the turn signal, carefully fold the lens [2] towards the

motorcycle and remove. Turn the cap [3] approx. 15° in a counterclockwise direction and

remove.

Slightly depress the bulb, turn it approx. 30° counterclockwise and pull it out of the socket.

To mount the lamp reverse the worksteps indicated above.When you mount the screw, first

turn it in a counterclockwise direction until it engages in the thread and then tighten slightly.

MAINTENANCE WORK ON CHASSIS AND ENGINE »

5 m

5 cm

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 85 86

Keine Kommentare

Ktm 950 R Bedienungsanleitung Seite 56